Conventional zone systems
Detection devices are grouped into zones; alarm location is indicated at zone level and field wiring must be assessed accordingly.
What to establish before changing a system
A shared brand name does not guarantee interoperability. Confirm the panel model, firmware, loop card, device generation, software access, approved configuration and installed equipment before proposing a change.
- 01Zone boundaries and indication resolutionCheck the installed panel, firmware, device generation, software access and approved configuration.
- 02Radial wiring and end-of-line supervisionCheck the installed panel, firmware, device generation, software access and approved configuration.
- 03Detector and call-point compatibilityCheck the installed panel, firmware, device generation, software access and approved configuration.
- 04Expansion limits and fault findingCheck the installed panel, firmware, device generation, software access and approved configuration.
Relevant brands and manufacturers
Marine addressable control in the specified Syncro ASM configuration
Aerosol extinguishing equipment subject to system compatibility and vessel acceptance
BDApp by emCT
Mobile facility monitoring, remote fire-alarm alerts and Fire Safe Zone visitor notification.
Ampac
Marine fire detection and alarm control in approved configurations
Compact local detection and extinguishing-release control
RAE Systems
RAE Systems for gas and flame detection.
Services for this requirement
We confirm service availability for the country, system and project requirements.
Technical Resources
How we compare fire safety solutions
Compare fire safety systems for your building, from product approvals and installation to maintenance and cost.
Read resource
Understanding fire safety approvals and certifications
Separate standards, marks, schemes and listing bodies.
Read resource
Browse the fire safety manufacturer directory
Find manufacturers, products, certifications and technical references.
Read resourceFrequently Asked Questions
Can devices from different protocols share one loop?
Usually not unless the control equipment and a specifically approved interface support that arrangement. Confirm exact compatibility.
Can an obsolete panel be replaced without changing field devices?
Sometimes, but only after checking loop protocol, device generation, loading, isolators, cause-and-effect and approval implications.
What should be captured before programming changes?
Back up the current configuration, identify the software and firmware versions, document the intended change and plan witnessed functional tests.